Main Rules Page 2 Page 3 Page 4 Page 5 Page 6  Page 7 Page 8 Page 9 Page 10 Page 11

Upon the start of an event, all paid registrants will receive 10 points per each class

providing the truck is present. No refunds.

In addition to the "registration" points, points will be awarded according to

placement starting with 20 and decreasing to 0. (i.e. 1st place= 20 points, 2nd place=

19 points, 20th place= 1 point, 21st place and down= 0 points)

If your vehicle should be unable to compete in your second points class due to

 a "breakage" in your first class, you will receive the points available for last place

in the second class (according to the number of entries) providing the vehicle is

determined by 3 members of WUMPA Board of Directors to be "movable under

its own power" before the finish of that second class. It is your responsibility to

contact a Board member, if you do not, you will only receive your

registration points. "

Vehicle qualifications to participate will be on the decision of the tech

officials and judges.  These rules will stand as a guideline for classes but

tech officials and judges shall decide the final decisions for safety.

          PLEASE MAKE YOUR VEHICLES AS SAFE AS POSSIBLE! 

                STOCK CLASSES 5500# & 6000#

Must be street legal. Vehicle must have Full factory interior.  (No gutting out!).  Racing type Bucket seats are OK for Driver But must have Passenger seat also or Full bench seat. Vehicle must have unmodified stock bumper.  Must have windshield, windows, instrument panel, working directionals, wipers, and doors No other alterations are allowed.  Holes in floors must be covered.

2. Any gasoline, diesel fuel, or LP gas may be used.  NO nitrous oxide. 

5 gal min. Fuel Cells allowed but must be securely fastened to vehicle.

3. No weight is to be added to the front of vehicle. (Weights must be inside the

box). Weights should be marked and must be secured.

4. Drivers must remove their own valve covers upon request.

5. Frame-mounted hitch must be in stock location and maximum drawbar  

height is 28" as measured from the ground to top of drawbar surface.  

Must be located a 40" minimum for short boxes and a 48" minimum 

for full - size from center of rear axle to hook point on clevis, or past 

stock uncut frame rails, whichever is further. Down pull must be supported 

at end of uncut frame rails. Hitch must be ridged in all directions During Pull.

6. Stock trucks may be trailered to the event.

7. Engine must be a standard production truck or automobile engine of 

the same manufacturer as vehicle, with a bolt-in installation using stock 

parts. No obviously  non-stock horsepower influencing equipment is

 permitted. Factory parts intended for racing or marine use are 

NOT permitted.

8. Any stock motor may be used in any model truck. Can only use cast iron 

parts.  (i.e. manifolds, heads, block, etc.).   

9. No headers allowed.  Dual exhaust is allowed.  You may not run with  

open exhaust, you must have mufflers.

10. Must have factory carburetor and intake manifold and retain all factory

 components.  No adapter plates.  Must have stock factory head and block

 with factory cast marking.  Must have stock rockers.  No Roller Cams or

Roller rockers unless Factory equipped for that year vehicle.

                                                                                                 3