Rules Page 8

6200# SUPER STOCK CLASS

1. Vehicle may not be stripped beyond safe operating conditions

(hood, fenders, doors). Factory box must have floor or cover.

2. A working safety kill switch is required to be within one (1) foot of hitch

and must have a neutral safety light. Kill switch must shut off fuel pump when pulled.

Recommended, main disconnect or battery kill switch located outside of the truck.

(SEE OPEN STOCK RULE #20 FOR SPECIFICATIONS)

3. Any gasoline, diesel, or LP gas may be used. No nitrous

oxide allowed. Alcohol is permitted.

4. Maximum drawbar height is 26" as measured from ground to

top of drawbar surface. Minimum drawbar length is 27% of

wheelbase. The attachment point may be 3/4" hole for a clevis or a

3" ID horizontal ring for a hook. Hitch length is to be no more

than 6" from rear bumper.

5. Weight must not exceed 60" from center of front axle to outer

edge of weight. No weights are allowed in the cab. Weights can

be anywhere on the frame, but they MUST be mounted.

6. Engine must be Cast Iron Block. One engine only.

Maximum of 530 CID. Pony Motors allowed.

7. 360 degrees Harmonic balancer guards are required for OEM Balancer.

SFI Approved Balancers only need Forward Guarding.

8.High port plates are allowed on Ford engines.

9. Headers are permitted. Can be Straight up thru hood or exiting down

and back. Extensions to side or through bed are permitted.

10. Any engine and drive line modifications permitted, except:

A. Only one (1) carburetor in normal position is permitted.

B. No tunnel rams, cross rams, TPI, turbo chargers,

or superchargers. Engines must be naturally aspirated.

11. Blank hood scoops may be added for appearance only.

12. All universal joints must be protected by minimum of 1/8'

or 1/4" aluminum, full 360-degree enclosure, at least 3" long,

centered on each U-joint, with 2 loops per drive shaft a least 1" wide.

13. Suspension modifications are permitted.